Create an Account - Increase your productivity, customize your experience, and engage in information you care about.
Fall is here and we all know the rainy season is upon us. We hope you will take time as the construction season slows down to proactively plan and install your erosion and sediment control measures. This is a good time to remind your employees and subcontractors to take the necessary actions to insure sediment remains on the development site during the upcoming rainy season.
As a reminder, erosion and sediment control measures on steep slopes need to be in place by October 15. Sites not protected are subject to a minimum of a $295 fine per day.
New residential or commercial site developments requesting final occupancy must have permanent erosion and sediment control measures in place before approval.
Construction permits for work on slopes of fifteen (15) percent and greater will not be issued after October 15, 2016, unless grading is completed and approved, and erosion and sediment control measures are established. The Parks and Community Development Director may, on a case-by-case basis, extend the October 15th date based on weather conditions at the time of the extension. "Request for Extension to Work in Steep Slope Hazard Area" forms are available to pick up at the Parks and Community Development Department office or can be downloaded from the City of Grants Pass "Erosion Control and Slope Hazards" page.
We appreciate the care and attention you have shown in past years regarding this issue. Each year the response to erosion and sediment control compliance improves. We are confident with proper planning this will be another successful year in our efforts to prevent sediment in the streets and storm drain system. By working together and being mindful of erosion and sediment control issues, we help keep our community and our natural resources clean and free of debris.
If you have any questions regarding erosion and sediment control measures, please visit the "Erosion Control and Slope Hazards" page linked below, or call the Engineering Division at 541-450-6060.